The Stinger SSVLBTN is a negative terminal with 1/0, 4, and two 8 AWG outputs, giving a clean place to land several cables at the battery. Negative battery terminal with four wire outputs. (1) 1/0 AWG, (1) 4 AWG and (2) 8 AWG ports. It suits amplifier installs where the battery terminal has to feed more than one run. Check your battery post style and planned wire gauges before ordering, since fit depends on the vehicle and battery.

The Stinger SSVLAGU is a water-resistant AGU fuse holder for 4 or 8 AWG, protecting your amplifier power wire close to the battery. AGU fuse holder accepts 4 or 8 AWG wire. water-resistant, small-footprint design. It suits new installs as well as replacing an older holder in an existing system. The fuse itself is not confirmed as included, so plan to order a fuse rated for your wire gauge and amplifier current draw.

The Stinger SSRCB2F is a twisted-pair RCA Y-adapter, 2 female to 1 male for splitting or combining RCA signals in a car audio system. 2 female to 1 male split for signal routing. tightly twisted-pair construction aids noise rejection. It is a handy part when you need to feed two amplifier inputs from one output, or bridge a pair of outputs into a single input. Check the plug genders on your equipment before ordering so the adapter matches your setup.

The Stinger SSPRCA3 is a 3 ft 2-channel coaxial RCA interconnect built to carry your source unit’s signal to an amplifier with minimal noise. Coaxial construction for dependable signal transfer. paired male-to-male RCA plugs. It is a straightforward way to replace a worn cable or plan a clean new amplifier install. Confirm the length you need by measuring your planned route from the radio to the amplifier, allowing extra slack for bends, panels, and connections at both ends.