When selecting an amplifier, the speakers must be taken into consideration. The amplifier should have synergy with the speakers weather they are component, coaxial, or subwoofers.
-
Jensen POWER400X4 4-Channel Power Series Amplifier
The Jensen POWER400X4 is a 4-channel Power Series amplifier rated at 400 watts maximum (peak). It uses 2×20 A fusing, #8 minimum power wire, and 2-ohm stereo / 4-ohm bridged minimum loads, with front/rear level, bass EQ, and LPF/HPF/full crossover controls. This listing uses the 400 W max (peak) rating only. POWER400X4 is a distinct 4-channel model from POWER400X2.
$99.99$129.99Jensen POWER400X4 4-Channel Power Series Amplifier
$99.99$129.99 -
JBL Stage GT 50011 Mono 500 W Amplifier with Bass Remote
Stage GT 50011 is a mono Class-D subwoofer amplifier rated 500 W RMS at 2 ohms and 300 W RMS at 4 ohms. A wired remote, variable phase, and bass EQ with adjustable level, width, and frequency (30–100 Hz) help tune the enclosure. Start/stop and OEM load detect support modern vehicles. Five hundred watts RMS at 2 ohms drives many single or dual-coil subs.
$249.95 -
JBL Stage GT 60041 4-Channel 65 W × 4 Amplifier
Stage GT 60041 is a compact Class-D four-channel amplifier rated 65 W RMS × 4 at 4 ohms, 90 W × 4 at 2 ohms, or 180 W × 2 bridged at 4 ohms. Variable 32–320 Hz crossovers, 0–12 dB bass EQ at 45 Hz, wide input sensitivity, OEM load detect, and start/stop compatibility support factory upgrades. Start/stop compatibility and OEM load detect help the amp behave with newer factory radios. Speaker-level inputs cover 1–25 V.
$229.95 -
Rockford Fosgate R2-300X4 Prime 4-Channel Amp
The Rockford Fosgate R2-300X4 is a Prime 300-watt 4-channel Class-D amplifier rated at 50 watts x 4 into 4 ohms, 75 watts x 4 into 2 ohms, or 150 watts x 2 bridged at 4 ohms. Top-mounted controls, C.L.E.A.N. setup indicators, and fully adjustable 12 dB/octave crossovers simplify a full-range or front/rear-plus-bridged-sub install. A cast aluminum heat sink and 4 AWG power terminals support daily driving.
$309.99 -
Kenwood KCARC01A Wired Bass Level Remote Control for eXcelon Amplifiers
Take control of your bass with the Kenwood KCARC01A Wired Subwoofer Level Controller, designed for compatible Kenwood eXcelon amplifiers. Its compact rotary knob lets you conveniently adjust subwoofer output from the driver’s seat without accessing the amplifier.
Featuring a 19.7-foot (6-meter) connection cable, a compact panel-mounted design, and simple wired operation, the KCARC01A offers convenient bass adjustments for your car audio system.
- Wired subwoofer level adjustment
- Compatible with select Kenwood eXcelon amplifiers
- 19.7 ft (6m) connection cable included
- Easy-to-use rotary control knob
- Compact dashboard mounting design
- RJ-25 cable connectors
- Mounting washer and hex nut included
- No batteries or wireless pairing required
$44.99 -
Rockford Fosgate PLC2 Remote Punch Level Control
Put bass level on the dash with the Rockford Fosgate PLC2 Remote Punch Level Control. The under-dash knob ships with a 16.5-foot RJ45 cable, mounting clip, and screws, plus an input clip LED that shows when the signal is getting hot. It works with many Punch and Power amplifiers that expose a PLC2 / Punch Level Control port on the chassis.
$49.99 -
Rockford Fosgate PEQ Remote Punch EQ Control
Tune Punch EQ from the dash with the Rockford Fosgate PEQ remote. It works with select 2007 and newer Punch and Power amplifiers over an RJ45 (8-conductor, non-flipped) connection and a 16.5-foot (503 cm) cable. Bass boost runs 0 to +18 dB at 45 Hz and treble 0 to +12 dB at 12.5 kHz, following the amp’s HP / LP / AP crossover mode. Mounting clip and screws are included.
$49.99 -
Rockford Fosgate T500X1br Power 500W Mono Amplifier
Park a half-kilowatt mono under a seat with the Rockford Fosgate T500X1br Power Series Class-BR amplifier. Continuous power is 175 watts RMS at 4 ohms, 300 watts at 2 ohms, and 500 watts at 1 ohm. Clip-detection LEDs, high-level auto turn-on, and PLC2 remote readiness suit compact subwoofer installs. Plan on 8 AWG power cable and a 60 Amp fuse (sold separately).
$299.99$329.99Rockford Fosgate T500X1br Power 500W Mono Amplifier
$299.99$329.99 -
Rockford Fosgate R2-250X1 Prime 250W Mono Amplifier
Start a focused subwoofer install with the Rockford Fosgate R2-250X1 Prime Series Class-D mono amplifier. It is rated 150 watts RMS at 4 ohms and 250 watts RMS at 2 ohms. On-board Punch EQ, a variable infrasonic filter, C.L.E.A.N. setup LEDs, high-level inputs, and an included RLC remote level control cover the basics of a clean bass system. A 50 Amp fuse is required and sold separately.
$249.99 -
Rockford Fosgate PBR400X4D Punch 400W 4-Channel Amp
Power a full front and rear stage from a tiny Punch chassis with the Rockford Fosgate PBR400X4D. Continuous output is 50 watts RMS x 4 at 4 ohms, 100 watts x 4 at 2 ohms, and 200 watts x 2 when bridged at 4 ohms. C.L.E.A.N. clip LEDs, selectable high-pass filters, and high-level inputs suit factory-radio upgrades. Plan on 8 AWG power cable and a 60 Amp fuse (sold separately).
$309.99 -
Rockford Fosgate M5-1500X5 1500W 5-Channel Element Ready Amp
The M5-1500X5 is a 1,500-watt 5-channel Element Ready amplifier for boats, UTVs, and other exposed installs. Front and rear channels use Class-AD topology, while the sub channel is Class-BD. Constant Power, C.L.E.A.N. clip LEDs, IPX6 seals, and PRESET mode for Rockford UTV kits round out the package for all-day listening. Plan charging capacity and wire gauge for a full 1,500-watt Class-AD/BD load.
$999.99 -
DS18 FRP25K
- 1 Channel Full Range
- Clip / Protection Indicator
- Remote Level Control Knob
$369.99DS18 FRP25K
$369.99