Rydeen BSS2LPB License Plate Radar Blind Spot Detection System
License-plate radar bar with GPS and reverse cross-traffic alerts
$699.00
Overview
The Rydeen BSS2LPB is a radar blind-spot detection system built into a bar that mounts above or below the rear license plate, so there is no drilling and no bumper removal. Two radar sensors inside the bar watch both blind spots and warn the driver with LED indicators on the A-pillars and a small buzzer. It also gives cross-traffic alerts while reversing. A GPS antenna keeps the side alerts off until the vehicle reaches a set speed (20 mph by default) to cut down false alerts. This is a driver aid, not a substitute for mirrors or a shoulder check.
Product details
How it works
The BSS2LPB uses microwave radar, which Rydeen says gives longer range and better accuracy than older ultrasonic blind-spot sensors. Both sensors sit inside a single bar at the license plate. When a vehicle approaches in either blind spot, the LED on that side lights and the buzzer can sound. Rydeen lists detection out to about 80 feet for trucks, 65 feet for cars, 50 feet for motorcycles and 45 feet for pedestrians, across a 52-degree horizontal field.
Speed activation and reverse alerts
The included GPS antenna senses vehicle speed. By default the side alerts switch on above 20 mph, and an installer can choose 15, 20, 25 or 30 mph instead. If the GPS cannot find a signal, the system works at any speed. In reverse, the kit warns of vehicles approaching from the left or right when backing out of a tight space.
Fit and installation
Rydeen designs the bar for vehicles with metal bumpers, such as pickup trucks, and says the system works on cars, vans and commercial vehicles too. The radar units are rated IP67 waterproof; the cables are not waterproof and should be routed inside the vehicle. It runs on 9–18V and draws under 100mA. Professional installation is recommended.
Key features
- Microwave radar sensors built into one license-plate bar
- No drilling and no bumper removal
- Two LED indicators for the A-pillars, plus an adjustable buzzer
- GPS speed activation: 20 mph default, selectable 15, 20, 25 or 30 mph
- Reverse cross-traffic alerts for vehicles approaching from either side
- Detection range up to about 80 ft for trucks and 65 ft for cars
- IP67 waterproof radar units
- Works on trucks, cars, vans and commercial vehicles
Important notes
- This is a driver aid only. It does not replace mirrors or a shoulder check before a lane change.
- Rydeen designs the bar for vehicles with metal bumpers, such as pickup trucks.
- The radar units are waterproof, but the cables are not.
- If no GPS signal is found, the system is active at any speed.
- Professional installation is recommended.
What's in the box
- Main unit (qty 1)
- Harness and extension cable (qty 1)
- BSS bar with two built-in sensors (qty 1)
- LED indicator, gray housing (qty 1)
- LED indicator, black housing (qty 1)
- GPS antenna (qty 1)
- Adjustable buzzer (qty 1)
- Velcro
- Screws and L-tool










